Vinten-radamec Head Processing Module (HPM) User Manual

Part No. V4014-0001www.vintenradamec.comENInstallation GuideHPMHead Processing ModuleInstallation

8InstallationMounting the HPMTo mount the HPM to a Vision 250E head, any fitted payload must be removed and it must be dismounted from its support. Al

9InstallationElectrical ConnectionsPower OptionsCable ClampUnscrew the cable clamp knob sufficiently to feed the cables into the channels through the

10InstallationGenlock I/O ConnectionsGenlockSource

11InstallationHead ConnectionEthernet ConnectionLens ConnectionUser Interface Connection

12Installation and MaintenanceStudio VR ConnectionVR Data Port Pin Designations.The VR Data port transmits the VR data to the studio VR graphics syste

13TroubleshootingFault Check CommentsHPM is switched on, but 5V and 12V indicator LEDs are not lit.Check that either a 50–60 Hz AC mains power supply

14Maintenance and General NoticesRoutine MaintenanceThe HPM requires minimal routine maintenance, apart from checking the connections and overall oper

15General NoticesFCC CertificationFCC NoticeThis product complies with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules.

16General NoticesEnvironmental ConsiderationsROHS Compliance StatementCamera Dynamics Limited is compliant with the European Union Directive 2002/95/E

Copyright © 2012All rights reserved.Original Instructions: EnglishAll rights reserved throughout the world. No part of this document may be stored in

VAVinten Radamecitec Group brandPublication part No. V4014-4980/1

1ContentsSafety & Warnings . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .

2Safety & WarningsImportant information on the safe installation and operation of this product. Read this information before operating the product

3Safety and WarningsBasic Electrical Insulation (Class 1 equipment)Mounting and InstallationWater, moisture and dustVentilationOperating EnvironmentCl

4About this ManualThe Vinten Radamec Head Processing Module (HPM) has been designed to integrate with the Vinten Vision 250E pan & tilt head, Cano

5Components and ConnectionsFront View1 . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Lens serial port2 . . . . . . . . . . . . . .

6Components and ConnectionsRear View10 . . . . . . . . . . . . . . . . . . . . . . . . . . . . Power IN (to HPM)11. . . . . . . . . . . . . . . . .

7InstallationBox Contents and Tools Required1 . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .HPM