Vinten-radamec Ci Box ICE Interface User Manual

Part No. V4115-0001www.vintenradamec.comENV4115-0002Installation and Configuration GuideCi Box ICE InterfaceCi Box ICE InterfaceInstallation

8Installation4. Continue to wrap and overlap the whole of the Velcro straps around the equipment and the Ci box so that the Velcro can secure it tight

9Installation2. Place the Ci box on a level surface with the underside facing upwards in the required orientation.3. Place the rack mount shelf over t

10Installation6. Fit the supplied cable clips to the back edge of the rack mount shelf to secure any connecting cables used in the installation.System

11InstallationRear Panel Data Connections Power ConnectionsPowering UpBefore powering up, ensure that all external cable connections have been secured

12ConfigurationData IndicationThe data indication LED shows the current system communication status of the Ci box.Adjusting the Modem Signal Level (Ci

13MaintenanceChanging the Data Baud Rate (Ci-1 Only)Depending on the requirements of the installation, the data baud rates of the modem input and outp

14TroubleshootingFault Check CommentsThe Ci box is not powering up.Check that the AC adaptor is connected and secured.See the section Rear Panel Data

15Technical Specification and General NoticesTechnical SpecificationPhysical DataWeight . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .

16General NoticesFCC Declaration of ConformityThis product complies with Part 15 of the FCC Rules. Operation is subject to the following two condition

Copyright © 2013All rights reserved.Original Instructions: EnglishAll rights reserved throughout the world. No part of this document may be stored in

VAVinten Radamecitec Group brandPublication part No. V4115-4980/1

1ContentsSafety. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .

2SafetyImportant information on the safe installation and operation of this product. Read this information before operating the product. For your pers

3Safety and About this ManualOperating EnvironmentCleaningMaintenanceAbout this ManualThe range of Vinten Radamec Ci box ICE interfaces have been desi

4Components and ConnectionsCi Box Front View1 . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .Power connector2 . . .

5Components and ConnectionsBox Contents Optional Accessories1 . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Ci box ICE

6InstallationTools RequiredPozidriv PZ-1 screwdriver.Potentiometer adjuster or small flat blade screwdriver.Mounting the Ci BoxThe Ci box is supplied

7InstallationFixing Kit Mounting1.Fit the screws through the holes in the Velcro straps, with washers either side of the straps.2. Attach the straps t